Furseth Machining, Inc.

Anodizing is an electrochemical process producing decorative and protective finishes on aluminum parts and products. Parts to be anodized are mounted on special racks that grasp, and allow a specified amount of electrical current to reach each piece.

The Anodizing takes place in an electrolyte solution of Sulfuric acid which converts the aluminum to aluminum oxide. . This aluminum oxide can be produced in thicknesses from as little as .0001 up to .0008 thick allowing for enhanced durability and organic dye absorption.

Wire EDM (Electrical Discharge Machining) process uses a thin single strand of wire which is fed through the workpiece in conjunction with de-ionized water. During this process electric current is used to cut conductive materials and leave behind a smooth surface that requires no additional finishing or polishing processes.

A process used to change the physical or chemical property of a material. Heat treatment of materials include: metal heat treatment - titanium heat treatment - heat treatment of aluminum alloys - heat treatment of stainless steel - heat treatment of brass - heat treatment of carbon steel - heat treatment of iron

a fabrication or sculptural process that joins materials, usually metals or thermoplastics, by causing fusion, which is distinct from lower temperature metal-joining techniques such as brazing and soldering, which do not melt the base metal.